Toggle SlidingBar Area
803.331.9233|Contact@CleatlessDock.com
FacebookInstagramLinkedin
CleatlessDock The Safe & Easy Solution Logo CleatlessDock The Safe & Easy Solution Retina Logo CleatlessDock The Safe & Easy Solution Mobile Logo CleatlessDock The Safe & Easy Solution Mobile Retina Logo
  • Home
  • Why Go Cleatless?
  • Installation
  • Place Order
  • About
  • Home
  • Why Go Cleatless?
  • Installation
  • Place Order
  • About
Installation RaisingSails 2017-04-13T22:58:11+00:00

Dock Requirements

  • Deck boards must be between ¾”x6” up to 2”x6” decking, deck boards must run a 90° angle to dock’s edge.

  • Must have 8 ¾” inch clearance below where the unit will be installed (no floats or frame lumber directly below not allowing the 8 ¾ inch clearance needed).

  • CleatlessDock should be mounted in a dock that is approx. 12″ above the water surface or more, this will insure 3+ inches of clearance between the bottom of the unit & the water.

How To Install CleatlessDock

STEP ONE

Center Template provided, over dock board where CleatlessDock unit will be installed into dock and install 2 screws to keep it from moving.

STEP TWO

Drill 8 each, ¼ holes through the Template and through adjacent deck boards, take care to drill a straight vertical hole.

STEP THREE

Draw a line across Template slot, this is where the dock board will be cut short.

STEP FOUR

Remove the Template. Cut the dock board, on the line drawn from the Template.

STEP FIVE

Install the Stainless Steel Trim into the open cut out.

STEP SIX

Reach through the Stainless Steel Trim, install washers & locking nuts onto all 8 hidden bolts on the bottom side of the deck boards. Snug them all up evenly insuring the Stainless SteeL Trim edge is pulled down flush with the deck boards.

STEP SEVEN

Install CleatlessDock unit into Stainless Steel Trim with 6 screws.

Visual Learner? Click the Pictures Below 

STEP ONE

Center Template provided, over dock board where CleatlessDock unit will be installed into dock...

STEP TWO

Drill 8 each, ¼ holes through the Template and through adjacent deck boards, take care to drill...

STEP THREE

Draw a line across template slot, this is where the dock board will be cut short....

STEP FOUR

Remove the Template. Cut the dock board, on the line drawn from the Template....

STEP FIVE

Install the Stainless Steel Trim into the open cut out....

STEP SIX

Reach through the Stainless Steel Trim, install washers & locking nuts onto all 8 hidden...

STEP SEVEN

Install CleatlessDock unit into Stainless Steel Trim with 6 screws....

YOU’RE NOW CLEATLESS!

Go Cleatless Today

Beginning in 2007, we set out to make the perfect docking system for boaters that ensured safety, endured extreme weather, and all the while looked good doing it. We're proud to say- we've accomplished that.

Contact Us

    803.331.9233

    Contact@CleatlessDock.com

    P.O. Box 151 Chapin SC, 29036



Order Now
CleatlessDock © 2017 | Designed beautifully by RaisingSails
FacebookInstagramLinkedin